discussion   |   photos   |   email   |   myProfile   |   home          Login Now | Sign Up


Forum Index


New As Posted | Active Subjects



Click to Post a New Message!

Discussion Boards > Active Subjects > Messages as Posted > Just For Fun Off Topic Forum

Page [ 1 ] |
Reply | Pop Up Window Reply | Add PhotoAdd Photo
 09-13-2002, 06:46 Post: 42341
TC33
2002-09-13 06:46:44
Post: 42341
 GeoThermal Heating Cooling

I am in the market for a new Heating and Cooling system and was wondering if anyone has any info on GeoThermal?






Reply to PostReply | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo




Bookmarks: Digg It | Del.icio.us |
 09-13-2002, 08:04 Post: 42342
Murf



View my Photos

View my Photos  Pics
Join Date: Dec 1999
Location: Toronto Area, Ontario, Canada
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster
Posts: 7054
 GeoThermal Heating Cooling

The concept is an excellent one, very efficient, and remarkably simple, using proven technology, albeit in a form other than the norm.

The two big problems normally encountered are 1) suitability, and 2) cost, especially for a retro-fit as compared to new construction.

If you live in a suitable area, prefferably one with a high water table, and few rocks, or on a river or lake, the cost of each BTU of energy attained is remarkably low, in fact only firewood is cheaper, and it can't (obviously) acheive cooling.

In fact I built a VERY crude geothermal A/C unit for my shop, water is pumped from a well-fed cistern, through a truck radiator set in the plenum of the wood-fired furnace (used in the winter to heat the place) and back to the cistern. It only brings the temp. down about 10-12 degrees F. but removes huge amounts of humidity (through condensation on the rad.) from the air. In fact last weekend was warm and very humid, 90 deg. & 95% humidity outside, but it was only 79 deg. & 40% humidity inside, which was MUCH nicer for working.

The big problem with a retro-fit is that you normally have to dig up a good part of your lawn to bury a 'ground loop' of piping to carry the brine solution. If, as I mentioned earlier however, you are close to a body of water (even a good-sized pond will work, you can just lay the coil in the water and your done.

Best of luck.






Reply to PostReply | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo




Bookmarks: Digg It | Del.icio.us |
 09-13-2002, 10:51 Post: 42347
MRETHICS



Join Date: Jul 2003
Location: Star City, Indiana
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster
Posts: 190
 GeoThermal Heating Cooling

My home has had a geo-thermal system for about 15 years, It has caused almost no trouble, and the bills are very cheap.

I do not have a loop system, but it could be plumbed that way. At the time of instalation, the contractor just hooked the discharge into a field tile. If I remember correctly, some regulations were put in place a few years ago, and It is not legal to do it that way now days, but older sytems like mine were grandfathered.

I have no idea if a loop system is more efficient than thye open system. I think it was an enviromental concern that lead to the regulations.

One benefit of these types of systems is the abundant supply of hot water they create. I plumbed in my old hot water heater, along with a torage tank wrapped with inulation. Now, I have 160 gal. of hot water. Enough to wash a car in the garage in Jan. and still have enough left for a shower when I'm done.






Reply to PostReply | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo




Bookmarks: Digg It | Del.icio.us |
 09-13-2002, 13:21 Post: 42352
Peters

TP Contributor

View my Photos

View my Photos  Pics
Join Date: Feb 2002
Location: Northern AL
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster
Posts: 3034

2
Filter by User
 GeoThermal Heating Cooling

I put a geothermal in the house I am building. I used closed loops and ran the distribution through the front yard. Depending on your location you don't need to be much deeper than 4-6 ft. You can use a trencher to do the work. I used a distibution system in side the basement, the ends of the tubing through the wall. The system I used recommends 3/4 inch tubing. I would recommend the cross linked PE material used for in floor heating. I have 3000ft of ground lines for 4 tons. All the hot water you can use with 100 gallons and 2 tanks.






Reply to PostReply | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo




Bookmarks: Digg It | Del.icio.us |
 09-13-2002, 14:35 Post: 42353
paul ruff



Join Date: Feb 2002
Location: iowa
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster
Posts: 11
 GeoThermal Heating Cooling

I put in a ground source heat pump about 7 years ago (4 ton 2 speed unit, heats and cools 3000+ sq ft house) it has around 3000 feet of lines in the ground, has hotwater heaters to recover some of the heat. I have had no trouble with this set up. Biggest advantage I have noticed with this system is it quiet.






Reply to PostReply | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo




Bookmarks: Digg It | Del.icio.us |
 09-13-2002, 17:14 Post: 42355
Peters

TP Contributor

View my Photos

View my Photos  Pics
Join Date: Feb 2002
Location: Northern AL
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster
Posts: 3034

2
Filter by User
 GeoThermal Heating Cooling

I agree there is little noise from the system. I was out side the other day by the barn and heard this roar from next door, took me a minute to figure out it was from the neighbour's airconditioner. He is about 1000 ft from the barn.






Reply to PostReply | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo




Bookmarks: Digg It | Del.icio.us |
Reply | Pop Up Window Reply | Add PhotoAdd Photo


Page [ 1 ] |

Discussion Boards > Active Subjects > Messages as Posted > Just For Fun Off Topic Forum

Thread 42341 Filter by Poster:
MRETHICS 1 | Murf 1 | paul ruff 1 | Peters 2 | TC33 1 |

 (advanced search)

Picture of the Day
brewdog

Site Members - brewdog - NW PA - NH 3040  Woods Hoe  Woods Mower  Woods Brush Hog
brewdog - NW PA - NH 3040 Woods Hoe Woods Mower Woods Brush Hog


Unanswered Questions

Gas Generator Weather Protecti
Horse Injured Polyrope Electri
Do electric fences keep out de
Any Peruvian Paso Owners Out T
gas powered post driver
My new born foal is really sic
Trailer Axle
dump trailer blueprints


Active Subjects

Gas Generator Weather Protecti
Went to see Dennis Reis this w
Signs to look for prior to lab
leg injury
Broodmare has welts all over h
Some Christmas Humor For Horse
poles in the ground vs. concre
ever thought about moving?


Hot Topics

new app owner
Some Christmas Humor For Horse
Any Peruvian Paso Owners Out T
Heating a Garage
Gas Generator Weather Protecti
Do electric fences keep out de
gas powered post driver
Trailer Axle


Featured Suppliers

Mountain Creek Labradoodles
      MountainCreekLabradoodles.com





New Forums on Gun Sport Shooting and Hunting -- BarrelPoint.com  New Forums on Horses ManePoint.com
Talk Horses at ManePoint
Hunting + Gun Sports at BarrelPoint



Most Viewed

+ Joke o the day
+ Vandalism or Civil Matter
+ Merry Christmas
+ -17 degrees F
+ New Implements
+ Colonoscopy Tuesday how did your s go
+ Motorcycles
+ Merry Christmas to all TP Members
+ Youth Christmas Gift Gun
+ What is your self-worth

Most Discussion

+ -17 degrees F
+ New Implements
+ one theory on Jobs
+ WHAT DID YOU DO TODAY
+ Empire farm days
+ Shooting at Mall in Kingston
+ Vandalism or Civil Matter
+ Joke o the day
+ A thought-provoking eye-opener
+ Hey Randy You are going to

Newest Topics

+ New Forums
+ The Tractorpoint Joke Thread
+ Things we say and what do they mean REALLY
+ Smile for the day Ole and Swen and others
+ Too much Snow Too Soon for me
+ Happy Thanksgiving
+ Commuting 335 miles to work
+ I m back
+ Some weather related news from North Dakota
+ How did you wind up where you are living Survey
















Turbochargers for Tractors and Industrial Machines
Cab Glass for Tractors and Industrial Machines

Alternators for Tractors and Industrial Machines
Radiators for Tractors and Industrial Machines

Driveline Components for Tractors and Industrial Machines
Starter Motors for Tractors and Industrial Machines