| Click to Post a New Message!
Page [ 1 ] |
|
|
Sealed combustion fireplaces
Anyone know anything about sealed combustion fireplaces? These seem to have most of the advantages of a woodstove insert but don't intrude into the room as far and wouldn't require a hearth extension. The only downside I see compared to some woodstoves is that wood goes in lengthwise and can roll out.
Link:  
|
|
Add Photo
Bookmarks: |
|
|
|
Sealed combustion fireplaces
They're suppose to be more efficient, I hear. Since the make-up air for combustion isn't the same air inside the house so you won't get drafts.
|
|
Add Photo
Bookmarks: |
|
|
|
Sealed combustion fireplaces
Those give you the fireplace look without the smoke in the house and heat up the chimney. They do not look anything like a wood insert. No drawback at all just kinda expensive but way better than just a fireplace and about as good as insert if not better because of the look you get. If you are worried about a log roll out just don't load it full all the time and you will be fine. Just always be prepared for anything to happen when the doors are open though!!
|
|
Add Photo
Bookmarks: |
|
|
|
Sealed combustion fireplaces
I wish the industry would standardize heat output ratings in a manner that could be compared apples to apples. The insert I was looking at is rated 12,000-50,800 BTUs on EPA Test Fuel (whatever that is) and 10,000-75,000 BTUs on cord wood. The sealed combustion fireplace is rated at up to 51,400 BTUs, no fuel specified. It seems they should be able to come up with a standard fuel load to measure maximum heat output under controlled conditions. My guess is the insert would provide a little more heat if only because it has more surface area in the room to radiate heat with.
|
|
Add Photo
Bookmarks: |
|
| |
|
Page [ 1 ] | Thread 146572 Filter by Poster: 1 | 2 | 1 |
|
()
Picture of the Day Coachlarry
Unanswered Questions
Active Subjects
Hot Topics
Featured Suppliers

|