| Click to Post a New Message!
Page [ 1 ] |
|
|
|
Stihl MS 290 Chainsaw Will Not Start Warm
I bought this model saw about four months ago to replace a similar size shindaiwa. Shindaiwa was not importing in the US then due to epa regs the best I could find out. In my shopping had both Husky and Stihl dealers to say the Shindaiwa was very good cranking saw. Was later told Echo bought Shindaiwa was in serious financially condition is why.
Well my experience with the Stihl has been very disappointing. I have a backpack blower of theirs about 17 years old and it cranks like a champ. I have a mixed of small engines and the worst of any to crank is this saw. So asked dealership on advice, some smart comments was about as good as I got. Looked at youtube on this and found some advice. Followed it and it worked fine for one afternoon.
Then this past Saturday needed to cut up some ice damage trees and when cold could crank the saw fine. Not near as good as the Shindaiwa but decent. Then ran it for a while and cut it off and it cranked okay. Then ran it again a few minutes due to cutting and loading onto trailer and the saw was not startable. It gave sound as if no fuel in the system just a dry turn over. My brother in law has same model and he tried and he failed. Dealership is convinced it is not the saw and it may not be. But this saw has me whipped on cranking when it has been run. I also had it to cut off while running if I let up on the throttle while cutting.
I am using 100% gas with stihl oil mixed to their ratio. I had friend tell me if that mixture is more than a month old it will not work. Does fine in my other two cycles.
For cold cranking put on choke for one pull, then off of choke to fast idle and make up to three pulls. It not started then back to choke for one more pull.
On starting after has been run have done same, also not used choke at all and it just shows no indication it will start.
thanks for your help, kt
|
|
 Add Photo
Bookmarks: |
|
| |
|
Stihl MS 290 Chainsaw Will Not Start Warm
If I heard you right you had a warm saw and you put it on choke for one pull then off choke fast idle for one to many pulls with result will not start.
On mine I have to be careful not to inadvertently set the throttle to Full choke on restart of warm saw or I can end up in the same boat as you.
Warm saw should have no choke. If it will not start on full throttle, then you might do one pull on choke, but you cannot start process with first pull on choke with warm saw IMHO.
|
|
Add Photo
Bookmarks: |
|
| |
|
Stihl MS 290 Chainsaw Will Not Start Warm
Stihl products as a rule. When cold, not run for the day, two pulls choke on, one with it at high throttle.
When warm one pull no choke.
They should idle with no problem so you do have a fuel issue, not to say it might not be the carb.
I do believe you possibly have a problem, you should be using premium fuel and stihl oil is one of the best.
|
|
Add Photo
Bookmarks: |
|
| |
|
Stihl MS 290 Chainsaw Will Not Start Warm
I'm with Art, to the letter, exactly what we do and never a problem.
Although I run regular fuel with home-brewed octane booster.
Best of luck.
|
|
Add Photo
Bookmarks: |
|
| |
|
Stihl MS 290 Chainsaw Will Not Start Warm
Kt,
If you haven't already done this.......
You might visit the youtube videos showing how to adjust the carb screws on your Stihl chainsaw. There are a few videos showing how to do this.
Here's one that you might find very useful. There are many others.
http://www.youtube.com/watch?v=3eLe6uyV_Vg
Joel
Link:
|
|
Add Photo
Bookmarks: |
|
| |
|
Stihl MS 290 Chainsaw Will Not Start Warm
Thank you all. So stay away from the choke unless totally cold. Do you use normal idle or fast idle when warm?
Joel, think I will take back to dealer to let them set carb. I assume still in warranty.
|
|
Add Photo
Bookmarks: |
|
| |
|
Page [ 1 ] | Thread 189174 Filter by Poster:
1 | 1 | 1 | 2 | 1 |
|
()
Picture of the Day
jarankin
Unanswered Questions
Active Subjects
Hot Topics
Featured Suppliers
|
Gas Generator Weather Protecti
02-24-2014, 09:00 
Digg It 
Del.icio.us 
