|
|
John deere amt600 5 Wheel gator
I have an amt 600 5 wheeler and I just got knew break pads for the back I went through and followed the directions that came with them but there is not enough room with both pads loaded in caliper to get it over the disk. I have both sides adjustek all the way out with the adjuster on back of caliper and both pistons look the same distance when all the way in I just cant get them to go on there is a little rust on disk but not that much any help would be great thanks a lot. Joe
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
I don't know about the Gator, this might sound stupid but are the brakes hydraulic? If so you might have to crack the bleeder a bit so the pistons can be pushed further in and then tighten it up right away to keep any air from being sucked into the system.
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
Joe, I am with Ken, not sure of the set up on Gator brakes but I have had to use a "C" clamp to pull the pistons back into the cyl for clearance on disk brakes before. Be sure you system is not sealed if you do so as there will be fluid needing to escape. kt
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
these breaks are cable operated and they are adjusted with a screw on back of caliper that pulls piston into bore my brother put them on he said he took the caliper bolts lose and took it appart to get them over the disk so I may try that to marrow any more ideas would be great thanks a lot. Joe
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
Can you please tell me where you purchased the brake pads for amt 600? Thank You Denton
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
I was able to go right to my johndeere dealer and told him what i needed for that machine and he found them and had them next day if you have any trouble I may have the package mine came in i will have to check to see if i can get the part number off of it good luck.
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
Prvious owner removed the Amt 600 I now have, and I'm not certain where they go. Could someone here tell which wires go where comparing theirs/?>
Thanks
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
Sorry i'm referring to the starter for the AMT600 I can't figure out where the wires go to which posts on the solenoid.
Thanks
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
I have a factory wiring diagram that I can probably scan and send to you if you haven't figured it out yet. Let me know. You can contact me at johandes@aol.com Jim
|
|
Add Photo
Bookmarks: |
|
|
|
John deere amt600 5 Wheel gator
johandes
If you still have that factory wiring diagram I sure would appreciate a copy. Just bought this used AMT 600 and it will only start by shorting at the starter. Thank you.
|
|
Add Photo
Bookmarks: |
|
|
|