| |
|
|
Starter sometimes clicks but won t start AMT600
It sounds like there may be a bad contact in one of the switches for the start circuit.
|
|
 Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
Before you get a switch. I would go to the start relay on the right side frame rail. It has a red a yellow and two purple wires. The yellow is the supply voltage to pull the relay and probably the smaller purple is the ground for the pull. The red is straight from the battery or starter and the other purple goes to the starter. The purple goes into the 6 prong connector at the motor and comes out red to the starter. First I would check the 6 prong connector if it is clean I would go for the relay.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
Before you get a switch. I would go to the start relay on the right side frame rail. It has a red a yellow and two purple wires. The yellow is the supply voltage to pull the relay and probably the smaller purple is the ground for the pull. The red is straight from the battery or starter and the other purple goes to the starter. The purple goes into the 6 prong connector at the motor and comes out red to the starter. First I would check the 6 prong connector if it is clean I would go for the relay.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
Just read your post. Got ignition sw and did not fix prob. I will try to locate the relay and check it. Thanks for the post.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
Are you sure that my old amt-600 has this relay? I cannot find it in the parts catalog.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
Sorry, my bad. I was thinking 6x4.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
So back to thinking 600. There are circuit breaker/ fuses up by the voltage regulator. the connections sometimes get rotten. They have little cap type connections and corrode over time.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
So back to thinking 600. There are circuit breaker/ fuses up by the voltage regulator. the connections sometimes get rotten. They have little cap type connections and corrode over time.
|
|
Add Photo
Bookmarks: |
|
|
|
|
Starter sometimes clicks but won t start AMT600
Ok. thanks I will check them.
|
|
Add Photo
Bookmarks: |
|
|
|
Gas Generator Weather Protecti
01-17-2017, 11:58 
Reply
Digg It 
Del.icio.us 