| Click to Post a New Message!
Page [ 1 ] |
|
|
Insulating material
I want to build small vertical insulating shafts (probably4"x4" or 6"x6" around plumbing lines where they come out of the ground and enter into the bottom of my pump house, and also where they come into the bottom of the house I'm about to build.
The idea is to fill them with some sort of granular insulating material so that no part of the plumbing system is exposed to freezing temps.
I'm thinking along the lines of something like the popcorn they use for shipping stuff, only something heavier and smaller in particle size.
Any ideas what sort of material would be good for this?
|
|
Add Photo
Bookmarks: |
|
|
|
Insulating material
well, styrofoam was not really what I had in mind. I wanted something a little more dense and small. Something that would have much of the characteristics of dirt, but not wick moisture or become a conduit for mold or spores or insects.
If it comes down to it, I guess I could make it about 18"x18" and fill it with sand or sawdust. Maybe I could treat the sawdust with something so that it doesn't wick water, becomes more desne and doesn't become attractive to any kind of insects.
Maybe clean sweep would work.
So far, lines that are underground or in a bed of sawdust have never frozen, even when left unattended for a time. But exposed lines (even those with the foam liners) have frozen.
I'm also planning to install a small recirc pump line in the ditch along with the supply line that will allow me to set the water heater to vacation mode and run water through the whole system if I leave home for extended periods.
Heat tped lines are way to expensive to install and run. But the little recirc pump only uses 35 watts and has a built in thermostat. By piping everyhing in series (except for risers) in the house and installing a ball valve between the hot and cold water riser at the farthest outlets, I could just open it when I plan to be away during the winter and set the WH to vacation.
But I was mostly concerned about insulation the copper lines where they exited the earth and entered the house as this will be about 4-5' I wanted to do something that was relativcely worry free and acted as if the pipe was buried in earth.
|
|
Add Photo
Bookmarks: |
|
|
|
Insulating material
quote
Really want to try everything else before I start adding more things that use power. Want to reduce my reliance on the grid as much as possible. So the heat tape will be a last resort .
__________
As for insulation, a common trick is to use a short length of small diameter plastic culvert, then fill it with expanded mica insulation. It will not absorb water and is not bug-friendly either.
___________
Now that's the kind of stuff I want to hear. Any links or placews you can point me to find out more about this 'expanded mica' stuff?
|
|
Add Photo
Bookmarks: |
|
|
|
Insulating material
shortmagnum:
I've looked on the web fro granular styrofaom insulation to find out more about it but come up empty. Any brand names or more info that might help me find the stuff?
Murf:
The expanded mica appears to be the same as vermiculite, which I've heard of and come into contact with here and there. But I would think that that stuff absobs water. Don't they use the stuff to saok up spills and such? Anyways, I'm trying to find out more about it's characteristics for my particular use, and not having much luck. They seem to use it for all kinds of stuff though, from insulation to water filtration and everything in between.
|
|
Add Photo
Bookmarks: |
|
| |
|
Page [ 1 ] | Thread 101082 Filter by Poster: 1 | 4 | 2 | 1 |
|
()
Picture of the Day adamhberkey
Unanswered Questions
Active Subjects
Hot Topics
Featured Suppliers
|