| Click to Post a New Message!
Page [ 1 ] |
|
|
|
pvc fittings
One last question before I install that new bladder tank.
What would be the best to use on the threads between the pvc and the galvonized pipe. My old system had galv. from the water supply line up to the copper that runs thru the house. I am switching it over to plastic from the bladder tank to the "T" that connects the water supply (from the well) and then up to the copper house lines.
What would be best, teflon tape or pipe dope between the plastic and galv. I was thinking the tape but was told by someone he would use the pipe thread sealant?
Is it either or or is one better than the other?
Thanks TOM
|
|
 Add Photo
Bookmarks: |
|
| |
|
pvc fittings
Harvey would you know what it was called?
Thankyou
Tom
|
|
Add Photo
Bookmarks: |
|
| |
|
pvc fittings
Thanks, where did you get it at? I done a search for it and founf nothing but good things said about it, so I then tried to find out twhere they sell it and could not come up with any hits?
Tom
|
|
Add Photo
Bookmarks: |
|
| |
|
pvc fittings
Since the middle of Dec. when I installed the new tank with all PLASTIC and no cast, I have not had a problem. (Shhh I did not want to say anything till a few months, you know that Murphys law)I use just regular old harveys sealant for the threads (all I could find in the store and since I had it already just used what I had). NO LEAKS and there is a heck of alot of water I can run between the pump turning on now.
Only thing I am not sure of is the pressure still wont stay up at 60psi. It shuts off at 60 and quickly drops to around 54 and stays there. Dont know if the older pipes in the other house has a light pressure leak and at 54 it is not large enough to push out anymore or what. But I am real happy with it at 54 down to 38 before it kicks. I used to have a 30/50 before I installed the larger 40/60.
I turned the setting on the new one to click off at 56 now and it turns on at 35. Thats more than enough pressure and dont want to create more of a headache than I need if too much pressure is on the older pipes?
Hey thanks for all the suggestions. In the end I followed my gut but you guys just reasured me and gave me the confidence that I was not messing up!
Thank you
TOM
|
|
Add Photo
Bookmarks: |
|
| |
|
Page [ 1 ] | Thread 102014 Filter by Poster:
1 | 4 | 3 | 1 | 2 |
|
()
Picture of the Day
Coachlarry
Unanswered Questions
Active Subjects
Hot Topics
Featured Suppliers
|
Gas Generator Weather Protecti
12-09-2004, 22:21 
Digg It 
Del.icio.us